Section 10. Electrical tests
Quiz Summary
0 of 9 Questions completed
Questions:
Information
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading…
You must sign in or sign up to start the quiz.
You must first complete the following:
Results
Results
0 of 9 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Categories
- Not categorized 0%
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 9
1. Question
A list itemizing details of equipment that may need to be inspected and tested is known as?
CorrectIncorrect -
Question 2 of 9
2. Question
Where IT equipment may be damaged by an applied voltage insulation resistance test, the test that would be carried out instead is?
CorrectIncorrect -
Question 3 of 9
3. Question
When an item of equipment has passed all the required inspection and testing, the attached label should not contain the words?
CorrectIncorrect -
Question 4 of 9
4. Question
Some electrical test equipment incorporates a test facility that is not recommended for in-service testing. This test facility is commonly known as; commonly known as;
CorrectIncorrect -
Question 5 of 9
5. Question
A measurement of 25MΩ was produced after an insulation resistance test was performed on a Class ll hand-held item. Six months later a test performed on the same item of equipment produced a measurement of 4MΩ. This would indicate that the equipment is?
CorrectIncorrect -
Question 6 of 9
6. Question
For standardisation, if a 230V appliance possesses an input rating of 650 W then the correct fuse size for the 3 pin plug would be?
CorrectIncorrect -
Question 7 of 9
7. Question
For standardisation, if a 230V appliance possesses an input rating of 900 W then the correct fuse size for the 3 pin plug would be?
CorrectIncorrect -
Question 8 of 9
8. Question
What is measured in Amps (Amperes)?
CorrectIncorrect -
Question 9 of 9
9. Question
What is the minimum insulation resistance required for a Class I appliance?
CorrectIncorrect